[cisco-voip] problem with ISDN and H323

victor rodriguez vrguez at hotmail.com
Mon Jan 4 12:22:52 EST 2010


 

Hi, i wish you a better year than 2009.

 

I have a problem with the following configuration. please help!!!!!!!!1

 

PSTN -----> PBX (Nortel) --ISDN---> RTR 2821 ----->CallManager -----> IPPHONE

 

I make a call form PBX to IPPHONE, i hear the ring, answered the call, but in the router the call is droped with user no answer.

 

*Jan  4 16:51:03.165: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8  callref = 0x4E00
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA9839F
                Exclusive, Channel 31
        Progress Ind i = 0x8581 - Call not end-to-end ISDN, may have in-band info
        Calling Party Number i = 0x0080, '5559996600'
                Plan:Unknown, Type:Unknown
        Called Party Number i = 0x81, '4965'
                Plan:ISDN, Type:Unknown
        Sending Complete

*Jan  4 16:51:03.181: ISDN Se0/0/0:15 SERROR: isdn_get_name_from_gtd: false ret
*Jan  4 16:51:03.181: ISDN Se0/0/0:15 SERROR: process_pri_simple: NO name in GTD
*Jan  4 16:51:03.181: ISDN Se0/0/0:15 Q931: TX -> CALL_PROC pd = 8  callref = 0xCE00
        Channel ID i = 0xA9839F
                Exclusive, Channel 31
*Jan  4 16:51:18.217: ISDN Se0/0/0:15 Q931: TX -> DISCONNECT pd = 8  callref = 0xCE00
        Cause i = 0x8092 - No user responding
*Jan  4 16:51:18.245: ISDN Se0/0/0:15 Q931: RX <- RELEASE pd = 8  callref = 0x4E00
*Jan  4 16:51:18.249: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8  callref = 0xCE00

 

I simulate  call usinf csim start IPPHONE, i answared the call and i see the established call

 

MXODFVPNNEOCCM#sh call act voi com
 <callID>  A/O FAX T<sec> Codec       type        Peer Address       IP R<ip>:<udp>
Total call-legs: 1
       220 ORG     T0     g729r8      VOIP        P4965    10.15.180.137:18236

 

If i make a call for IPPHONE to PBX it works

 

MXODFVPNNEOCCM#
*Jan  4 16:56:31.837: ISDN Se0/0/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x0, Calling num 4965
*Jan  4 16:56:31.841: ISDN Se0/0/0:15 Q931: Sending SETUP  callref = 0x00AC callID = 0x802D switch = primary-qsig interface = User
*Jan  4 16:56:31.841: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8  callref = 0x00AC
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98381
                Exclusive, Channel 1
        Calling Party Number i = 0x0081, '4965'
                Plan:Unknown, Type:Unknown
        Called Party Number i = 0x80, '2071'
                Plan:Unknown, Type:Unknown
*Jan  4 16:56:31.921: ISDN Se0/0/0:15 Q931: RX <- CALL_PROC pd = 8  callref = 0x80AC
        Channel ID i = 0xA98381
                Exclusive, Channel 1
*Jan  4 16:56:31.925: ISDN Se0/0/0:15 Q931: RX <- ALERTING pd = 8  callref = 0x80AC
        Progress Ind i = 0x8182 - Destination address is non-ISDN
*Jan  4 16:56:47.273: ISDN Se0/0/0:15 Q931: RX <- CONNECT pd = 8  callref = 0x80AC
        Progress Ind i = 0x8182 - Destination address is non-ISDN
*Jan  4 16:56:47.273: ISDN Se0/0/0:15 SERROR: isdn_init_name_iecs: Connected name not supported for this switch type
*Jan  4 16:56:47.273: %ISDN-6-CONNECT: Interface Serial0/0/0:0 is now connected to 2071 N/A
*Jan  4 16:56:47.273: %ISDN-6-CONNECT: Interface Serial0/0/0:0 is now connected to 2071 N/A
*Jan  4 16:56:47.273: ISDN Se0/0/0:15 Q931: TX -> CONNECT_ACK pd = 8  callref = 0x00AC
*Jan  4 16:57:34.045: %ISDN-6-DISCONNECT: Interface Serial0/0/0:0  disconnected from 2071 , call lasted 46 seconds
*Jan  4 16:57:34.049: ISDN Se0/0/0:15 Q931: TX -> DISCONNECT pd = 8  callref = 0x00AC
        Cause i = 0x8090 - Normal call clearing
*Jan  4 16:57:34.077: ISDN Se0/0/0:15 Q931: RX <- RELEASE pd = 8  callref = 0x80AC
*Jan  4 16:57:34.077: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x00AC

 

 

 
 		 	   		  
_________________________________________________________________
Keep your friends updated—even when you’re not signed in.
http://www.microsoft.com/middleeast/windows/windowslive/see-it-in-action/social-network-basics.aspx?ocid=PID23461::T:WLMTAGL:ON:WL:en-xm:SI_SB_5:092010
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100104/5dc79e3d/attachment.html>


More information about the cisco-voip mailing list