[cisco-voip] Unity Connection

[Cheng, Karen]

When you say you did the MWI synch did you do the one on the phones themselves?

That's what  I normally do.

Under Message Waiting Indicators in the users settings and then select the MWI-1 and then reset all.

Regards

Karen Cheng
Voice Network Engineer



From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of John.VanLaecke at ghd.com
Sent: Wednesday, 10 November 2010 10:52 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Unity Connection

Hello All,

I have a few phones that do now have sync with the MWI light on the phone.
I have done the mwi sync in unity with no change,, is there anything else I can try ?

Version is 7.0.1ES41.21021-41




Regards,

John Van Laecke
Senior Voice Engineer


_____________________
This email and all attachments are confidential. For further important information about emails sent to or from GHD or if you have received this email in error, please refer to http://www.ghd.com/emaildisclaimer.html .
_____________________
This e-mail has been scanned for viruses by MessageLabs.

75% of inspected vehicle have a defect*. Call 13 1905 and book an RACQ Vehicle Inspection today. *Based on the RACQ Vehicle Defect Report January 2008


Please Note: If you are not the intended recipient, please delete this email as its use is prohibited. RACQ does not warrant or represent that this email is free from viruses or defects. If you do not wish to receive any further commercial electronic messages from RACQ please e-mail unsubscribe at racq.com.au or contact RACQ on 13 19 05.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20101110/f2830307/attachment.html>