[cisco-voip] New to Cisco Voice - Need to Setup Fax

[Nick Matthews]

Check this out, 15.1(1)T:
http://www.cisco.com/en/US/docs/ios/voice/fax/configuration/guide/vf_cfg_t38_fxrly_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1179536

2011/8/4 Jason Gurtz <jasongurtz at npumail.com>:
> The vast majority here is on a hierarchical LAN w/ routing in the access
> layer (4507R-E access and 4900M cores) and we're using plain jane
> auto-qos. Seems to me like your Metro-E setup is doing just fine.
>
> I'm not sure about the version question; we are on the latest 8.5.1 so
> maybe Lelio can comment?
>
> ~JasonG
>
>
>> -----Original Message-----
>> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-
>> bounces at puck.nether.net] On Behalf Of Alex Lindsay
>> Sent: Thursday, August 04, 2011 08:57
>> To: cisco-voip at puck.nether.net
>> Subject: Re: [cisco-voip] New to Cisco Voice - Need to Setup Fax
>>
>> What is your network topology look like?  With my MetroE network I'm
>> getting about 1-2ms jitter and 2-3ms ping from remote site to data
>> center.
>> We have very basic QoS setup atm but working on full MPLS with end to
> end
>> QoS later this year.
>>
>> Do you think running IOS 15 with older CME (7.0/4.3) would give me the
>> fax speed benefit, or am I looking at an upgrade to 8+?
>>
>> My Regards,
>>
>> Alexander A. Lindsay
>> WaveTech Systems
>> http://wavetechs.com
>> O: 305.224.1563
>> F: 305.865.0622
>> C: 305.903.7592
>> alex at wavetechs.com
>>
>> -----Original Message-----
>> From: cisco-voip-bounces at puck.nether.net
>> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Gurtz
>> Sent: Thursday, August 04, 2011 8:50 AM
>> Cc: cisco-voip at puck.nether.net
>> Subject: Re: [cisco-voip] New to Cisco Voice - Need to Setup Fax
>>
>> We have VG224 and 204 in place since all the bizness people are addicted
>> to their old fashioned fax. They've worked quite well for us, though we
>> had a heck of a time trying to figure out how to set a slower fax speed
>> on a Xerox 6180mfpd.
>>
>> I was pretty stoked to see the other post saying higher speeds would
> work
>> with IOS 15; can't wait to try :)
>>
>> ~JasonG
>>
>> > -----Original Message-----
>> > From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-
>> > bounces at puck.nether.net] On Behalf Of Alex Lindsay
>> > Sent: Thursday, August 04, 2011 08:03
>> > To: Baris Gulten
>> > Cc: cisco-voip at puck.nether.net
>> > Subject: Re: [cisco-voip] New to Cisco Voice - Need to Setup Fax
>> >
>> > Thanks for all ideas and options but unfortunately I do not have the
>> > option of removing every users analog fax machine.   I have to find a
>> > reliable solution that will work with ATA's and the PRI I have.
>> >
>> >
>> >
>> > My Regards,
>> >
>> >
>> >
>> > Alexander A. Lindsay
>> >
>> > WaveTech Systems
>> >
>> > http://wavetechs.com <http://wavetechs.com/>
>> >
>> > O: 305.224.1563
>> >
>> > F: 305.865.0622
>> >
>> > C: 305.903.7592
>> >
>> > alex at wavetechs.com
>> >
>> >
>> >
>> > From: Baris Gulten [mailto:barisgulten at gmail.com]
>> > Sent: Thursday, August 04, 2011 7:17 AM
>> > To: Alex Lindsay
>> > Cc: cisco-voip at puck.nether.net
>> > Subject: Re: [cisco-voip] New to Cisco Voice - Need to Setup Fax
>> >
>> >
>> >
>> > Dude, I'm tryed before Imagicle Stone Fax software with pri lines.
>> >
>> > Its so usefull.
>> >
>> > Sent from my iPhone
>> >
>> >
>> > On 03 Ağu 2011, at 17:00, Alex Lindsay <alex at wavetechs.com> wrote:
>> >
>> >     Hello,
>> >
>> >
>> >
>> >     I have a small MetroE network and I would like to consolidate my
>> > Faxing as I have done with my Voice.  I have a 7200vxr with VXB T1
>> > card to connect to my PRI (that I got with the anticipation of fax
>> > oIP, to be frank, sucking).  Am starting to use that same PRI for in
>> > LATA calls managed by my local SBC but my primary LD is sent to a ITSP
>> via SIP.
>> >
>> >
>> >
>> >     My question and thoughts are as follows;  What is the simplest
>> > solution to support about 25 Fax attached ATA's (spa8000, spa2102 &
>> > Audiocodes MP-2032) to the voice gateway (PRI router)?  I was thinking
>> of
>> > setting up a Cisco 2821 (that I already have) with a PVDM2-32/64 and
>> > CME
>> > 4.3/7 with a SIP trunk to the voice gateway.
>> >
>> >
>> >
>> >     Forgive my ignorance.  I am a diehard R&S guy and got through into
>>
>> > the Voice world.
>> >
>> >
>> >
>> >     ·         Do I need to PVDM2 if I am doing only SIP to SIP?
>> >
>> >     ·         Does that version of CME support T.38 well or at all?
>> >
>> >     ·         What is this Fax Relay all about and do I need it? I am
>> > reading mixed reviews.
>> >
>> >
>> >
>> >     Thank you for any advice, help or information.
>> >
>> >
>> >
>> >
>> >
>> >     My Regards,
>> >
>> >
>> >
>> >     Alexander A. Lindsay
>> >
>> >     WaveTech Systems
>> >
>> >     http://wavetechs.com <http://wavetechs.com/>
>> >
>> >     O: 305.224.1563
>> >
>> >     F: 305.865.0622
>> >
>> >     C: 305.903.7592
>> >
>> >     alex at wavetechs.com
>> >
>> >
>> >
>> >     _______________________________________________
>> >     cisco-voip mailing list
>> >     cisco-voip at puck.nether.net
>> >     https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>