[cisco-voip] Meet Me Conferencing - choose specific CFB

[Bill Riley]

I think when you hit meetme and dial the number you are associated with the
CFB on the server that has the MeetMe number registered to it. 

 

From: Damian Turburville [mailto:d_turburville at yahoo.com] 
Sent: Monday, January 31, 2011 7:32 AM
To: Bill Riley; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] MeetMe Conferencing - choose specific CFB

 

I dont believe so. When you initiate a MeetMe conference, the CFB you are
allocated is on the basis of the MRGL configured on the phone. I have a test
phone with an MRGL with only hardware CFB within it and it does choose these
when I initiate the MeetMe conference. I wondered if there was a way of
choosing the CFB based upon the number dialled rather than the phones MRGL.
DT

 

  _____  

From: Bill Riley <bill at hitechconnection.net>
To: Damian Turburville <d_turburville at yahoo.com>; cisco-voip at puck.nether.net
Sent: Mon, January 31, 2011 1:11:10 PM
Subject: RE: [cisco-voip] MeetMe Conferencing - choose specific CFB

When you do a Meeteme number conference bridge it is always using the
software CFB on the server. 

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Damian Turburville
Sent: Monday, January 31, 2011 3:44 AM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] MeetMe Conferencing - choose specific CFB

 

Anyone?

 

  _____  

From: Damian Turburville <d_turburville at yahoo.com>
To: cisco-voip at puck.nether.net
Sent: Thu, January 27, 2011 10:50:53 AM
Subject: [cisco-voip] MeetMe Conferencing - choose specific CFB

Hi,
I am pretty sure you cant do this but I will ask anyway :-)
I have a CUCM 6 cluster (1 Pub, 2 Sub) with various CFB configured, some
hardware on the PSTN routers (max participants 8) and some software on the
CUCM servers themselves (max participants 48)
I have a MeetMe range of numbers configured (6301 - 6304) and an MRGL
associated with my phone that is set to use the HW CFB (max participants 8)
So all of this means that I can setup MeetMe conferences that can take a max
of 8 participants from my phone (I believe the conf bridge is allocated on
the basis of the configured MRGL for the endpoint that initiates the conf).
Now if there was a need for a large conference for some reason, I would have
to associate my phone with a different MRGL so I would access the SW CFB
rather than the HW CFB when I press the MeetMe button. This would be
annoying.
Is there any way of associating the MeetMe number with a specific CFB? i.e.
could I have 6301 and 6302 using the HW CFB and 6303 and 6304 using the SW
CFB?
Cheers,
DT

 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110131/8157801c/attachment.html>