[cisco-voip] DSP issue

[John.VanLaecke at ghd.com]

All,

I have the issue of ;

config-controller)#pri-group timeslots 1-20
% Not enough DSP resources available to configure pri-group on controller 
E1 1/1
% The remaining dsp resources are enough for 0 time slots.
% For current codec complexity, 2 extra dsp(s) are required to create this 
voice port.


Here is the strange part

I have the following dsp's


NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 4", DESCR: "PVDMII 
DSP SIMM with four DSPs"
PID: PVDM2-64          , VID: V01 , SN: 

NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 5", DESCR: "PVDMII 
DSP SIMM with four DSPs"
PID: PVDM2-64          , VID: V01 , SN: 

NAME: "PVDMII DSP SIMM with Two DSPs on Slot 0 SubSlot 6", DESCR: "PVDMII 
DSP SIMM with Two DSPs"
PID: PVDM2-32          , VID: V01 , SN: 


I have unassigned the DSP from the transcoder and conference bridge and 
still the same error

any ideas ?



Regards,

John Van Laecke 
Senior Voice Engineer


_____________________ 
This email and all attachments are confidential. For further important information about emails sent to or from GHD or if you have received this email in error, please refer to http://www.ghd.com/emaildisclaimer.html .
_____________________ 
This e-mail has been scanned for viruses by MessageLabs.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110321/51706b21/attachment.html>