[cisco-voip] dial-peer

[Abebe Amare]

Hi,

To configure the E1 port for R2 signalling,

AS5350(config)# *controller e1 0/0*
AS5350(config-controller)# *ds0-group 1 timeslots 1-30 type r2-analog
r2-compelled ani*

the R2 signalling type depends on your PSTN connection.

Configure the dial-peers as below:

dial-peer voice 10 pots
incoming called-number .
direct-inward-dial

port 0/0:D

dial-peer voice 2 voip

  destination-pattern x... <- this is the access number

  session target ipv4:x.x.x.x <- this is the IP of the SysMaster GW

Check the following documents for more detail

http://www.cisco.com/en/US/docs/routers/access/as5350/software/configuration/guide/54bas3.html#wpxref17473

http://www.cisco.com/en/US/docs/routers/access/as5350/software/configuration/guide/54voice_ps501_TSD_Products_Configuration_Guide_Chapter.html

regards,

2011/11/15 Цэвээндорж <tseveendorj at gmail.com>

> Hello,
>
> I don't know how called it technically. Let me try to explain what I'm
> trying to do.
> I have SysMaster SM7000 gateway and billing also. I cannot connect to PSTN
> via E1 with R2 signaling. I thought I cannot configure sysmaster correctly
> then I ask from sysmaster guys but reply as follow
>
>  Basically, we can support this requirement you have but NOT on the
>> current HW you have.
>>
>> If you need to support MFC/R2 signaling with your current SM7000, then it
>> will cost you just as much for custom development as it would to just
>> purchase a new SM7000 GW that can support it already.
>>
>
> Now let's begin
> I have cisco gateway AS5350XM (Version 12.4(20)T1) with 4xE1 card using
> current system. I'm planning interconnect to PSTN with cisco gateway +1xE1
> with R2 signaling. My topology looks like this.
>
> Access number ---> PSTN ----------E1--------> Cisco gateway without IVR
> ----------TCP/IP---------> Sysmaster gateway with IVR
>
> I don't know how to configure when user dials to Access number (example
> 1626) then Cisco gateway without IVR receive request and immediately send
> to Sysmaster gateway with IVR and customer should hear the IVR.
>
>
> Any help will be appreciated.
>
> Regards,
> Tseveen.
> ______________________________**_________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/**mailman/listinfo/cisco-voip<https://puck.nether.net/mailman/listinfo/cisco-voip>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20111115/d5bf746f/attachment.html>