[cisco-voip] CUCM 8.0.3.20000-2 - Network Failover DOWN!

[Matthew Saskin]

You don't need the ether-channel configuration.  For CUCM NIC teaming the
switch ports should just be plain old access ports, no LACP.

-matthew


On Sat, Oct 15, 2011 at 11:11 AM, dschulz <dschulz at skyline-ats.com> wrote:

> Gig interface should be set to auto
>
> Dave
>
>
> On Oct 15, 2011, at 10:59 AM, "Buchanan, James" <jbuchanan at presidio.com>
> wrote:
>
> For starters, your Ethernet interfaces on the server are set to auto
> negotiate, but on the switch are hard-coded. Big no-no. Change the switch
> side first.****
>
> ** **
>
> *James Buchanan*|* UC Technology Manager *| *Presidio South *|*Presidio Networked Solutions
> *****
>
> *12 Cadillac Dr Ste 130 Brentwood, TN 37027 *|* **jbuchanan at presidio.com**
> *
>
> *D: 615-866-5729* | *F:615-866-5781*  *www.presidio.com*<http://www.presidio.com/>
> ****
>
> ** **
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Michel L. M. B. Perez
> *Sent:* Saturday, October 15, 2011 9:41 AM
> *To:* <cisco-voip at puck.nether.net>cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] CUCM 8.0.3.20000-2 - Network Failover DOWN!****
>
> ** **
>
> Hello Peolple,
>
> I have TWO DC, my publisher is connected to a Cisco 6504 Switch and de
> Subscriber is connected to 6509, my problem is that i´ve enabled bond0
> interface (nic teaming at this two MCS7835 servers), but the port-channel is
> not coming up neither from the server side and from the switch side, anyone
> here has this working? Here are some outputs from my 6509.
>
> Server Config
>
> admin:show network failover
> Bond 0
> DHCP         : disabled           Status     : up
> IP Address   : 10.5.3.216         IP Mask    : 255.255.000.000
> Link Detected: no                 Mode       : Auto disabled, N/A, N/A
>
> Ethernet 0
> DHCP         : disabled           Status     : up
> IP Address   :                    IP Mask    :
> Link Detected: yes                Mode       : Auto enabled, Full, 1000MB/s
>
> Ethernet 1
> DHCP         : disabled           Status     : up
> IP Address   :                    IP Mask    :
> Link Detected: yes                Mode       : Auto enabled, Full, 1000MB/s
>
> DNS
> Primary      : 10.5.3.3           Secondary  : 10.5.3.102
> Options      : timeout:5 attempts:2
> Domain       : xxx.xxx.xx
> Gateway      : 10.5.2.1 on Ethernet bond0
>
> Switch Config
>
> interface Port-channel11
>  description description #### LACP - SRV-CUCM-FLN02 ####
>  switchport
>  switchport mode access
>  spanning-tree portfast edge
>  spanning-tree bpduguard enable
>
> interface GigabitEthernet1/41
>  description #### CUCM - ETH1 ####
>  switchport
>  switchport mode access
>  speed 1000
>  duplex full
>  no cdp enable
>  channel-group 11 mode active
>  spanning-tree portfast edge
>  spanning-tree bpduguard enable
>
> interface GigabitEthernet1/42
>  description #### CUCM - ETH2 ####
>  switchport
>  switchport mode access
>  speed 1000
>  duplex full
>  no cdp enable
>  channel-group 11 mode active
>  spanning-tree portfast edge
>  spanning-tree bpduguard enable
>
>
> SW_6509E(config-if-range)#do sh etherc 11 summ
> Flags:  D - down        P - bundled in port-channel
>         I - stand-alone s - suspended
>         H - Hot-standby (LACP only)
>         R - Layer3      S - Layer2
>         U - in use      N - not in use, no aggregation
>         f - failed to allocate aggregator
>
>         M - not in use, no aggregation due to minimum links not met
>         m - not in use, port not aggregated due to minimum links not met
>         u - unsuitable for bundling
>         d - default port
>
>         w - waiting to be aggregated
> Number of channel-groups in use: 11
> Number of aggregators:           12
>
> Group  Port-channel  Protocol    Ports
>
> ------+-------------+-----------+-----------------------------------------------
> 11     Po11(SD)        LACP      Gi1/41(I)      Gi1/42(I)
>
> Last applied Hash Distribution Algorithm:   -
>
> SW_6509E(config-if-range)#
>
>
> ****
>
> --****
>
> Michel Perez****
>
> Skype: michelmbperez****
>
> <michelmbperez at gmail.com>michelmbperez at gmail.com****
>
> <http://br.linkedin.com/in/michelmbperez>
> http://br.linkedin.com/in/michelmbperez****
>
> ** **
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20111015/f55dc849/attachment.html>