[cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

[Joseph Mays]

Yeah, but I believe I am running the enhanced image. If I plug in the name of the firmware in the cisco feature navigator and it says my software has the feature then I must be running enhanced image, right? If not, how do I tell whether I have the SI or the EI?
  ----- Original Message ----- 
  From: Jason Aarons (AM) 
  To: Joseph Mays 
  Sent: Thursday, September 01, 2011 5:35 PM
  Subject: RE: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS


  Wasn’t their two versions, Standard Image and Enhanced Image, I’m thinking those commands  are in the Enhanced Image but can’t recall.

   

   

   

  From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Joseph Mays
  Sent: Thursday, September 01, 2011 2:43 PM
  To: cisco-voip at puck.nether.net
  Subject: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

   



  I've got a Cisco 2950 here with IOS version 12.1.22(EA4). According to the 
  cisco feature navigator, when I look up this image by the name of the IOS 
  image name, auto qos is recognized. But whenever I try to enter "auto qos 
  voip trust" on an interface, or any qos command anywhere, actually, I get 
  "invalid input detected" (pointing at the word "auto" in the auto qos case). 
  None of the auto qos or other qos commands seem to be in the command set. Do 
  I need a different IOS (or is there some other 2950 I need for this)?

  Joe

  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net 
  https://puck.nether.net/mailman/listinfo/cisco-voip 


  itevomcid 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110902/fef82c48/attachment.html>