[cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

[Matthew Loraditch]

It's the actual model of the switch that determines it,  I think it had to be a 2950G
What is your exact model?


Matthew Loraditch, CCVP, CCNA, CCDA
1965 Greenspring Drive
Timonium, MD 21093
support at heliontechnologies.com<mailto:support at heliontechnologies.com>
(p) (410) 252-8830
(F) (443) 541-1593

Visit us at www.heliontechnologies.com<http://www.heliontechnologies.com/>
Support Issue? Email support at heliontechnologies.com<mailto:support at heliontechnologies.com> for fast assistance!

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Joseph Mays
Sent: Friday, September 02, 2011 11:47 AM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

Yeah, but I believe I am running the enhanced image. If I plug in the name of the firmware in the cisco feature navigator and it says my software has the feature then I must be running enhanced image, right? If not, how do I tell whether I have the SI or the EI?
----- Original Message -----
From: Jason Aarons (AM)<mailto:jason.aarons at dimensiondata.com>
To: Joseph Mays<mailto:mays at win.net>
Sent: Thursday, September 01, 2011 5:35 PM
Subject: RE: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

Wasn't their two versions, Standard Image and Enhanced Image, I'm thinking those commands  are in the Enhanced Image but can't recall.



From: cisco-voip-bounces at puck.nether.net<mailto:cisco-voip-bounces at puck.nether.net> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Joseph Mays
Sent: Thursday, September 01, 2011 2:43 PM
To: cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
Subject: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS



I've got a Cisco 2950 here with IOS version 12.1.22(EA4). According to the
cisco feature navigator, when I look up this image by the name of the IOS
image name, auto qos is recognized. But whenever I try to enter "auto qos
voip trust" on an interface, or any qos command anywhere, actually, I get
"invalid input detected" (pointing at the word "auto" in the auto qos case).
None of the auto qos or other qos commands seem to be in the command set. Do
I need a different IOS (or is there some other 2950 I need for this)?

Joe

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip


itevomcid
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110902/24cbfa25/attachment.html>