[cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

[Joseph Mays]

WS-C2950-24
  ----- Original Message ----- 
  From: Matthew Loraditch 
  To: Joseph Mays ; cisco-voip at puck.nether.net 
  Sent: Friday, September 02, 2011 11:50 AM
  Subject: RE: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS


  It's the actual model of the switch that determines it,  I think it had to be a 2950G

  What is your exact model?

   

   

  Matthew Loraditch, CCVP, CCNA, CCDA
  1965 Greenspring Drive

  Timonium, MD 21093 
  support at heliontechnologies.com
  (p) (410) 252-8830
  (F) (443) 541-1593

  Visit us at www.heliontechnologies.com 
  Support Issue? Email support at heliontechnologies.com for fast assistance!

   

  From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Joseph Mays
  Sent: Friday, September 02, 2011 11:47 AM
  To: cisco-voip at puck.nether.net
  Subject: Re: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

   

  Yeah, but I believe I am running the enhanced image. If I plug in the name of the firmware in the cisco feature navigator and it says my software has the feature then I must be running enhanced image, right? If not, how do I tell whether I have the SI or the EI?

    ----- Original Message ----- 

    From: Jason Aarons (AM) 

    To: Joseph Mays 

    Sent: Thursday, September 01, 2011 5:35 PM

    Subject: RE: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

     

    Wasn't their two versions, Standard Image and Enhanced Image, I'm thinking those commands  are in the Enhanced Image but can't recall.

     

     

     

    From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Joseph Mays
    Sent: Thursday, September 01, 2011 2:43 PM
    To: cisco-voip at puck.nether.net
    Subject: [cisco-voip] auto qos not recognized on Cisco 2950 with EI IOS

     



    I've got a Cisco 2950 here with IOS version 12.1.22(EA4). According to the 
    cisco feature navigator, when I look up this image by the name of the IOS 
    image name, auto qos is recognized. But whenever I try to enter "auto qos 
    voip trust" on an interface, or any qos command anywhere, actually, I get 
    "invalid input detected" (pointing at the word "auto" in the auto qos case). 
    None of the auto qos or other qos commands seem to be in the command set. Do 
    I need a different IOS (or is there some other 2950 I need for this)?

    Joe

    _______________________________________________
    cisco-voip mailing list
    cisco-voip at puck.nether.net 
    https://puck.nether.net/mailman/listinfo/cisco-voip 


    itevomcid 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110902/3676f382/attachment.html>