[cisco-voip] quick sanity check on factory reset

[Lelio Fulgenzi]

are there enough addresses in that scope? we've had issues where too much testing exhausts the DCHP scope. not common, but something else to check. 

--- 
Lelio Fulgenzi, B.A. 
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1 
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN) 
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
Cooking with unix is easy. You just sed it and forget it. 
- LFJ (with apologies to Mr. Popeil) 


----- Original Message -----
From: "Erick A. Wellnitz" <erick.wellnitz at kattenlaw.com> 
To: "Lelio Fulgenzi" <lelio at uoguelph.ca> 
Cc: cisco-voip at puck.nether.net 
Sent: Monday, September 12, 2011 11:37:01 AM 
Subject: RE: [cisco-voip] quick sanity check on factory reset 




I was just double checking because I have two bricked 7911s (one from a site and one from me testing). Packet captures show the phone getting DHCP but no tftp traffic. I know the DHCP scope is correct because my desk phone is using that same scope without issue. 







I have a TAC case open 





From: Lelio Fulgenzi [mailto:lelio at uoguelph.ca] 
Sent: Monday, September 12, 2011 9:55 AM 
To: Wellnitz, Erick A. 
Cc: cisco-voip at puck.nether.net 
Subject: Re: [cisco-voip] quick sanity check on factory reset 




We covered this earlier in a fairly interesting thread, I think it boiled down to this: Whatever was the last firmware loaded on the TFTP server will be the load that the phone will try to load after a factory default reset. 

If you are "testing" a new SIP load and that was the last firmware you loaded, a factory reset will force the phone to load a SIP load. 

If you are "testing" a new SCCP load, don't like it, then revert the default firmware load to what you had before, when you perform a factory reset, it will load the newer SCCP firmware first, then load the default SCCP firmware, so basically doing the upgrade twice. 

It all depends on the termXXdefault.xml or something like that. 

I believe you can download/edit/upload them as required so you don't have to fool around with installing firmware files. 

I'm sure others will correct me, but I'm pretty sure this is the dealio. 

--- 
Lelio Fulgenzi, B.A. 
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1 
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN) 
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
Cooking with unix is easy. You just sed it and forget it. 
- LFJ (with apologies to Mr. Popeil) 


----- Original Message -----


From: "Erick A. Wellnitz" <erick.wellnitz at kattenlaw.com> 
To: cisco-voip at puck.nether.net 
Sent: Monday, September 12, 2011 10:33:56 AM 
Subject: [cisco-voip] quick sanity check on factory reset 




I’m doing a factory reset on a 7911 which has SCCP firmware 8.3(2) installed. My CUCM has 9.0(3) as the default. 



This should factory reset without issue, correct? 



ERICK A. WELLNITZ 
Network Engineer 
Katten Muchin Rosenman LLP 


	=========================================================== CIRCULAR 230 DISCLOSURE: Pursuant to Regulations Governing Practice Before the Internal Revenue Service, any tax advice contained herein is not intended or written to be used and cannot be used by a taxpayer for the purpose of avoiding tax penalties that may be imposed on the taxpayer. =========================================================== CONFIDENTIALITY NOTICE: This electronic mail message and any attached files contain information intended for the exclusive use of the individual or entity to whom it is addressed and may contain information that is proprietary, privileged, confidential and/or exempt from disclosure under applicable law.  If you are not the intended recipient, you are hereby notified that any viewing, copying, disclosure or distribution of this information may be subject to legal restriction or sanction.  Please notify the sender, by electronic mail or telephone, of any unintended recipients and delete the original message without making any copies. =========================================================== NOTIFICATION:  Katten Muchin Rosenman LLP is an Illinois limited liability partnership that has elected to be governed by the Illinois Uniform Partnership Act (1997). =========================================================== 


_______________________________________________ 
cisco-voip mailing list 
cisco-voip at puck.nether.net 
https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110912/106e1dc4/attachment.html>