[cisco-voip] Integration cisco router 2911 with Ericsson pbx

ANAS ALMOKAYYAD anooos12168 at hotmail.com
Wed Apr 3 09:20:34 EDT 2013


How can i fix it to accept 5 digit ?

On Apr 3, 2013, at 12:57 PM, "Dana Tong" <Dana_Tong at bridgepoint.com.au> wrote:

> Hi Anas,
>  
> The debugs show the PBX is using overlap send/ receive. The router has received only one digit and is attempting to route the call but there are no dial-peers to route the digit.
>  
>                 Calling Party Number i = 0x0181, '803'
>                                 Plan:ISDN, Type:Unknown
>                 Called Party Number i = 0xC9, '1'
>  
>>  
>  
>>  
> Apr  2 09:07:06.190: ISDN Se0/0/0:15 Q931: RX <- INFORMATION pd = 8  callref = 0x0009
>                 Called Party Number i = 0xC9, '0' 
>                                 Plan:Private, Type:Subscriber(local)
>  
>  
> Your dial-peers are 5 digits beginning with 84XXX, 86XXX, and 87XXX.
>  
> Check the PABX is sending the correct numbers and you might need to increase the T.302 timers on the ISDN interfaces (int serial 0/0/0:15…)
>  
> Cheers
> Dana
>  
>  
> From: ANAS ALMOKAYYAD [mailto:anooos12168 at hotmail.com] 
> Sent: Wednesday, 3 April 2013 4:45 PM
> To: Zoltan.Kelemen at Emerson.com; Dana Tong; cisco-voip at puck.nether.net
> Subject: RE: [cisco-voip] Integration cisco router 2911 with Ericsson pbx
>  
> thanks for response ...
> dears please find the attached error and the scenario and the routers configurations  ...
> 
> > From: Zoltan.Kelemen at Emerson.com
> > To: Dana_Tong at bridgepoint.com.au; anooos12168 at hotmail.com; cisco-voip at puck.nether.net
> > Date: Tue, 2 Apr 2013 22:29:22 +0000
> > Subject: RE: [cisco-voip] Integration cisco router 2911 with Ericsson pbx
> > 
> > Dana, for me it seems it's just Ericsson to Ericsson with an IP tie line. If it's SIP of H.323 there's no need for a CUCM whatsoever in between.
> > 
> > Anas, can you share output from q931 debugs?
> > Are you sure that the numbers you are sending in towards the called PBX are in the right format for that PBX to accept?
> > Ex. You may be sending five digits to the PBX when the PBX expects four only, or vice versa.
> > 
> > Cheers,
> > 
> > Zoltan Kelemen
> > ETS & Information Security 
> > Implementation Engineering
> > w: +40 374 132356 | m: +40 757 039093
> > 
> > 
> > -----Original Message-----
> > From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Dana Tong
> > Sent: Wednesday, April 03, 2013 12:45 AM
> > To: ANAS ALMOKAYYAD; cisco-voip at puck.nether.net
> > Subject: Re: [cisco-voip] Integration cisco router 2911 with Ericsson pbx
> > 
> > Hi there,
> > 
> > Not so much information there but having a guess. Assuming you have Cisco IP phones calling Ericsson phones via Qsig integration? Or is it CUCM in the middle with MGCP gateways providing IP tie-lines for Ericsson PBXs?
> > 
> > What is the exact topology? Is the problem with calls from Cisco IP phones to Ericsson phones?
> > Or is the topology just Ericsson to Ericsson over IP with CUCM in the middle providing the call control?
> > 
> > If the problem for example is calls from Ericsson to Cisco IP phones, have you checked the inbound CSS on the MGCP gateway? 
> > 
> > If the problem is the other direction, perhaps you need to configure overlap send/ receive? Are the numbers in the correct format? What about type/ plan?
> > 
> > Cheers
> > Dana
> > 
> > -----Original Message-----
> > From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of ANAS ALMOKAYYAD
> > Sent: Wednesday, 3 April 2013 7:19 AM
> > To: cisco-voip at puck.nether.net
> > Subject: [cisco-voip] Integration cisco router 2911 with Ericsson pbx
> > 
> > Dears 
> > 
> > I face a problem when i integrate 2911 e1 card with Ericsson pbx in two different site to call each other through vpn I used isdn qsig to integration ....
> > Channels all up and i get tone from router but when i called another site its fail... 
> > when i debug the call it show me "invalid format number" incomplete number ... 
> > Any one have an idea about cause of this error ...
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> > 
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20130403/0bdfa4c5/attachment.html>


More information about the cisco-voip mailing list