[cisco-voip] DX80 issues.

[Brian Meade]

It just depends on what the DX80 is pointed at.  If it's set to use the pub
as TFTP server 1 then you're fine.

On Fri, Jun 16, 2017 at 3:12 AM, naresh rathore <nareh84 at hotmail.com> wrote:

> is it necessary to active tftp service on cucm-sub? or
>
>
>
> when i point it to cucmpub. i succesfuly downloaded the file using tftp.
> but when i pointed it to cucmsub, the file was 0byte, not successfully
> downloaded (because tftp is not enabled on cucmsub.
>
>
>
> Regards
>
>
>
> Naray
>
>
> ------------------------------
> *From:* bmeade90 at gmail.com <bmeade90 at gmail.com> on behalf of Brian Meade <
> bmeade90 at vt.edu>
> *Sent:* Friday, June 16, 2017 11:38 AM
> *To:* naresh rathore
> *Cc:* cisco-voip at puck.nether.net
> *Subject:* Re: [cisco-voip] DX80 issues.
>
> You can try restarting TFTP.  Also see if you can download the .loads file
> with a TFTP Client.
>
> On Fri, Jun 16, 2017 at 2:13 AM, naresh rathore <nareh84 at hotmail.com>
> wrote:
>
>> hi,
>>
>>
>>
>> I am facing two issues with DX80.
>>
>>
>>
>>
>>    1. First, video call is not successful with DX80. when i check self
>>    view (while not on call).there is nothing. so i think there can be issue
>>    with the camera. video call is enabled on Device > Phone and between video
>>    and phone device pool, the codec is G711, maximum session bit rate for
>>    video calls: 384kbps, maximum session bit rate for immersive video calls:
>>    1024kbps
>>
>>
>>
>>       2. Second, is the upgrade (may be upgrade will resolve camera
>> issue) . Currently DX80 is on android firmware and the required firmware is
>> also android. I use ftp/sftp to upload the file on both cucm, on one cucm
>> tftp service is active while on another cucm (sub), tftp is not active but
>> i uploaded file on both of them and can see the .load file on tftp file
>> management. but see the following status after upgrade (upgrade failed).
>>
>>
>> *Registration:* Registered with Cisco Unified Communications Manager
>> CUCM02
>> *IPv4 Address:* x.x.x.x <http://10.163.167.14/>
>> *Active Load ID:* sipdx80.10-2-2-23
>> *Inactive Load ID:* INVALID
>> *Download Status:* Failed
>> *Requested Load ID:* sipdx80.10-2-4-99
>> *Download Server:* 10.163.72.100
>> Inactive Load Failure Reason File Not Found
>> Any suggestions.
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20170616/6e82b0be/attachment.html>