[cisco-voip] can make conference call when i use IP communicator (same settings as 7942), but the conference call is not working when i use 7942 phone

['Jonatan Quezada']

we use the meet me,  where the call comes in on a bridge DN. I will try in
test scenario tomorrow.

On May 3, 2017 5:14 PM, "Ryan Huff" <ryanhuff at outlook.com> wrote:

> Couple of questions ...
>
> Do both devices have access to the same MRGL/MRG in CUCM?
>
> Does the 7942's audio codec region match the region of where the
> disconnected party comes from (ex. PSTN gateway) or does it need transcoded?
>
> -Ryan
>
>
> On May 3, 2017, at 8:04 PM, naresh rathore <nareh84 at hotmail.com> wrote:
>
> hi,
>
>
>
> I am facing this  issue in which, when i use the 7942 phone, the
> conference call fails. it disconnect one of the party and keep it as point
> to point call. but when i use same settings on ip communicator (connected
> via vpn), the conference call works. 7942 firmware version
> SCCP42.9-3-1SR3-1S
>
>
>
> CUCM Version: 9.1.2.11900-12
>
>
> Regards
>
>
>
> Naresh Rathore
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20170503/9fb00dbd/attachment.html>