[cisco-voip] can make conference call when i use IP communicator (same settings as 7942), but the conference call is not working when i use 7942 phone

[naresh rathore]

it started working for one spoke site but other spoke sites are still not working.



will check tomorrow.


________________________________
From: cisco-voip <cisco-voip-bounces at puck.nether.net> on behalf of naresh rathore <nareh84 at hotmail.com>
Sent: Thursday, May 4, 2017 6:10 AM
To: Ryan Huff
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] can make conference call when i use IP communicator (same settings as 7942), but the conference call is not working when i use 7942 phone


Upgraded the phone firmware and it started working


________________________________
From: cisco-voip <cisco-voip-bounces at puck.nether.net> on behalf of naresh rathore <nareh84 at hotmail.com>
Sent: Thursday, May 4, 2017 5:51 AM
To: Ryan Huff
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] can make conference call when i use IP communicator (same settings as 7942), but the conference call is not working when i use 7942 phone


both IP communicator and 7942 access MRGL via same device pool. Also, it remote site and using the CUBE at HQ site.  both IP Communicator and 7942 phone use G729 to make external calls and use CUBE MRGL having hardware Conference as first preference and Hardware Transcoding  as second preference.



remote site: region is LID

HQ: region is HQ

its set to use 8Kbps


Device Pool on Hardware Conf use HQ Region


Device pool on Hardware Transcoder use Moh region (G711 with every other region)



The thing is I used the Same device pool on IP Communicator but conference call on IP communicator is working fine. may be i am connected to HQ via vpn and the CUBE is also in HQ. but device pool is same as remote /spoke site.



Regards


Naresh Rathore


________________________________
From: Ryan Huff <ryanhuff at outlook.com>
Sent: Thursday, May 4, 2017 5:14 AM
To: naresh rathore
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] can make conference call when i use IP communicator (same settings as 7942), but the conference call is not working when i use 7942 phone

Couple of questions ...

Do both devices have access to the same MRGL/MRG in CUCM?

Does the 7942's audio codec region match the region of where the disconnected party comes from (ex. PSTN gateway) or does it need transcoded?

-Ryan


On May 3, 2017, at 8:04 PM, naresh rathore <nareh84 at hotmail.com<mailto:nareh84 at hotmail.com>> wrote:


hi,



I am facing this  issue in which, when i use the 7942 phone, the conference call fails. it disconnect one of the party and keep it as point to point call. but when i use same settings on ip communicator (connected via vpn), the conference call works. 7942 firmware version SCCP42.9-3-1SR3-1S



CUCM Version: 9.1.2.11900-12


Regards



Naresh Rathore

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20170504/c7fed161/attachment.html>