[cisco-voip] CUBE Config Dial Peers

[Jinto Alakkal]

Hi Jason,

If you go through the below cisco live slides it has simple examples to configure the dial peers for your requirement.

https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2019/pdf/BRKCOL-2125.pdf


Thanks!

Jinto

________________________________
From: cisco-voip <cisco-voip-bounces at puck.nether.net> on behalf of JASON BURWELL via cisco-voip <cisco-voip at puck.nether.net>
Sent: Friday, June 12, 2020 3:06 PM
To: cisco-voip at puck.nether.net <cisco-voip at puck.nether.net>
Subject: [cisco-voip] CUBE Config Dial Peers


CAUTION: This email originated from outside of the University of Guelph. Do not click links or open attachments unless you recognize the sender and know the content is safe. If in doubt, forward suspicious emails to IThelp at uoguelph.ca


Does anyone have a good, straightforward reference doc to configuring CUBE dial peers? I have what I would have thought should be a fairly basic config but I’m having trouble getting everything to work properly. I’ve had some assistance but it seems like a whole lot of configuration to do what little I really need to do. Basically, I just need to send whatever comes from CUCM- either 10, 11 or 3 digits in the SIP invite for outbound and for inbound calls the provider sends me 10 digits in the invite, I just need to strip off the first 6 and send the last 4 to CUCM to route. I have a lot of adding and stripping digits going on between CUCM and CUBE to make this work. Just trying to find reference docs to see if any of this can be cleaned up. Thanks
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20200612/b2b62c2b/attachment.htm>