[cisco-voip] CUBE Config Dial Peers

[Kent Roberts]

Best thing to do is separate out the ins and outs by addresses. Set up a set for in/out with the carrier.  Like 1..2..3...   and set up a set for your cucm.  10..11..12.    Do you have a config that your working on?


Kent

> On Jun 12, 2020, at 13:12, JASON BURWELL via cisco-voip <cisco-voip at puck.nether.net> wrote:
> 
> 
> Does anyone have a good, straightforward reference doc to configuring CUBE dial peers? I have what I would have thought should be a fairly basic config but I’m having trouble getting everything to work properly. I’ve had some assistance but it seems like a whole lot of configuration to do what little I really need to do. Basically, I just need to send whatever comes from CUCM- either 10, 11 or 3 digits in the SIP invite for outbound and for inbound calls the provider sends me 10 digits in the invite, I just need to strip off the first 6 and send the last 4 to CUCM to route. I have a lot of adding and stripping digits going on between CUCM and CUBE to make this work. Just trying to find reference docs to see if any of this can be cleaned up. Thanks
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20200612/1b7841b4/attachment.htm>