[f-nsp] Line Cards not Booting on NI-MLX-4

[Jeroen Wunnink]

Is there enough power available in the chassis ?, I've had issues with 
booting up a single linecard if there was only 1 powersupply connected.

Chuck Ufarley wrote:
> Hi all--
>
> I've got a couple of NI-MLX-1Gx20-SFPs that I'm trying to bring up on 
> an NI-MLX-MR running 4.00ca, and I can't get the cards to boot.  They 
> keep looping through a "CARD_STATE_BOOT" "CARD_STATE_SW_LOADED " 
> "CARD_STATE_SYNC_FID" loop, but won't come up active.  I can't update 
> the lp files unless the card comes up.  I've tried this:
>
> Config t
>  lp boot system interactive [slot#]
> exit
>  wr mem
> Power-off lp [slot#]
> Power-on lp [slot#]
> lp boot system mp primary [slot#]
>
> and the lp images load from the mp, but they don't seem to stick, 
> because the line card doesn't go active.
>
> Do I need to issue a "no lp boot system interactive" + new "wr mem" + 
> reload command to get it up and running?  It doesn't seem to work.  Am 
> I missing something obvious.
>
> Help is extremely appreciated.  I'm a little stumped right now.
>
> Thanks.
>
> --Chuck
> ------------------------------------------------------------------------
>
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp

-- 

Met vriendelijke groet,

Jeroen Wunnink,
EasyHosting B.V. Systeembeheerder
systeembeheer at easyhosting.nl

telefoon:+31 (035) 6285455              Postbus 48
fax: +31 (035) 6838242                  3755 ZG Eemnes

http://www.easyhosting.nl
http://www.easycolocate.nl