[f-nsp] WG: IPv6 on BigIron?

[Clement Cavadore]

Hi,

B2P08001t works fine with IPv6.
Regards,

Clément


On Tue, 2009-12-08 at 11:55 +0100, Gunther Stammwitz wrote:
> Hello Clement,
> 
> which exact software tree are you referring to?
> 
> I was trying to enable v6 on 8001u (08.0.01uT53 / B2R08001u.bin) but didn't
> have success.
> Is the B2R-image the correct version set? My modules are jetcore (J-BxGMR4).
> 
> 
> Can't find the appropriate manual :-( 
> The v6 manual from April (IPv6_April2009_Config_Guide.pdf) just says
> IronWare
> Software 07.7.02 and higher.
> 
> 
> Thanks,
> Gunther
> 
> [apologies for dupes - had to send the message again due to spam protection]
> 
> > -----Ursprüngliche Nachricht-----
> > Von: foundry-nsp-bounces at puck.nether.net [mailto:foundry-nsp-
> > bounces at puck.nether.net] Im Auftrag von Clement Cavadore
> > Gesendet: Donnerstag, 8. Oktober 2009 00:55
> > An: Joseph Hardeman
> > Cc: foundry-nsp at puck.nether.net
> > Betreff: Re: [f-nsp] IPv6 on BigIron?
> > 
> > Hi,
> > 
> > 
> > Le mercredi 07 octobre 2009 à 18:19 -0400, Joseph Hardeman a écrit :
> > > Yes, the J-BxGMR4 will do IPv6, but you need to have a software
> > > version greater than 08.0.x.
> > 
> > 
> > More precisely: You need Jetcore module *and* software equals to 08.x.
> > 9.x or 7.x do not have any IPv6 features.
> > 
> > However, Jetcore manager runs a fully software-based IPv6 routing.
> > 
> > Regards,
> > 
> > Clément
> > 
> > _______________________________________________
> > foundry-nsp mailing list
> > foundry-nsp at puck.nether.net
> > http://puck.nether.net/mailman/listinfo/foundry-nsp
> 
> 
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp