[f-nsp] ServerIron XL, VLANs, DSR, Management...

[Oliver Adam]

Dual-mode is not supported at the ServerIron XL as far as I remember 
- dual-mode ports are only available using the devices which came out 
after the XL. The XL is a pretty old box.

- Oliver

At 23:36 12.01.2009, Calvin Gorriaran wrote:
>Content-Language: en-US
>Content-Type: multipart/alternative;
> 
>boundary="_000_3DFFCADFA43AB74890E06352129CDE6C19D707EDE9MBX1EXCHPRODU_"
>
>Hi Mike,
>
>These are my choices in an interface that has been tagged. I think I 
>may just be too far behind on firmware.
>
>ver 07.4.01T12
>
>(config-if-e100-1)#
>   auto-gig               Handshaking with other Gig port to 
> exchange capability
>                          info
>   broadcast              Broadcast traffic
>   cache-group            TCS cache group
>   clear                  Reset functions/remove keys
>   dhcp-gateway-list      DHCP Assist - set gateway address for each subnet
>   disable                Disable
>   enable                 Enable
>   end                    End config-level commands
>   exit                   Exit current level commands
>   flow-control           802.3x flow control on full duplex port
>   fw-group               firewall group
>   ip                     IP commands
>   ip-multicast-disable   Disable IP multicast on this interface
>   ip-policy              IP access filter commands
>   ipg10                  Inter-Packet Gap delay for 10M Ethernet
>   ipg100                 Inter-Packet Gap delay for 100M Ethernet
>   ipg1000                Inter-Packet Gap delay for Gig Ethernet
>   mac                    MAC filter commands
>   monitor                Monitored port
>   multicast              Multicast traffic
>   neg-off                No handshake for the port
>   no                     Undo commands
>   phy-mode               Bay 28000 compatibility mode
>   port-name              Assign alphanumeric port name
>   pvst-mode              Interoperate with Cisco PVST+ for 
> multi-spanning tree
>   qos-priority           QOS priority
>   quit                   Exit to user level
>   rshow                  Remote show system information
>   show                   Show system information
>   spanning-tree          STP port commands
>   speed-duplex           100 or 10, half or full
>   unknown-unicast        Unknown unicast
>   write                  Write running configuration to memory or terminal
>
>_______________________________________________
>foundry-nsp mailing list
>foundry-nsp at puck.nether.net
>http://puck.nether.net/mailman/listinfo/foundry-nsp