[f-nsp] ServerIron XL, VLANs, DSR, Management...

[Mike Allen]

Yeah, I wasn't sure about that, I am probably thinking about the newer
chassis code.  Sorry Calvin.

Mike
On Mon, Jan 12, 2009 at 2:42 PM, Oliver Adam <oadam at madao.de> wrote:

> Dual-mode is not supported at the ServerIron XL as far as I remember -
> dual-mode ports are only available using the devices which came out after
> the XL. The XL is a pretty old box.
>
> - Oliver
>
> At 23:36 12.01.2009, Calvin Gorriaran wrote:
>
>> Content-Language: en-US
>> Content-Type: multipart/alternative;
>>
>> boundary="_000_3DFFCADFA43AB74890E06352129CDE6C19D707EDE9MBX1EXCHPRODU_"
>>
>>
>> Hi Mike,
>>
>> These are my choices in an interface that has been tagged. I think I may
>> just be too far behind on firmware.
>>
>> ver 07.4.01T12
>>
>> (config-if-e100-1)#
>>  auto-gig               Handshaking with other Gig port to exchange
>> capability
>>                         info
>>  broadcast              Broadcast traffic
>>  cache-group            TCS cache group
>>  clear                  Reset functions/remove keys
>>  dhcp-gateway-list      DHCP Assist - set gateway address for each subnet
>>  disable                Disable
>>  enable                 Enable
>>  end                    End config-level commands
>>  exit                   Exit current level commands
>>  flow-control           802.3x flow control on full duplex port
>>  fw-group               firewall group
>>  ip                     IP commands
>>  ip-multicast-disable   Disable IP multicast on this interface
>>  ip-policy              IP access filter commands
>>  ipg10                  Inter-Packet Gap delay for 10M Ethernet
>>  ipg100                 Inter-Packet Gap delay for 100M Ethernet
>>  ipg1000                Inter-Packet Gap delay for Gig Ethernet
>>  mac                    MAC filter commands
>>  monitor                Monitored port
>>  multicast              Multicast traffic
>>  neg-off                No handshake for the port
>>  no                     Undo commands
>>  phy-mode               Bay 28000 compatibility mode
>>  port-name              Assign alphanumeric port name
>>  pvst-mode              Interoperate with Cisco PVST+ for multi-spanning
>> tree
>>  qos-priority           QOS priority
>>  quit                   Exit to user level
>>  rshow                  Remote show system information
>>  show                   Show system information
>>  spanning-tree          STP port commands
>>  speed-duplex           100 or 10, half or full
>>  unknown-unicast        Unknown unicast
>>  write                  Write running configuration to memory or terminal
>>
>> _______________________________________________
>> foundry-nsp mailing list
>> foundry-nsp at puck.nether.net
>> http://puck.nether.net/mailman/listinfo/foundry-nsp
>>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20090112/c41e21e7/attachment.html>