[f-nsp] Not able to use XMR 10 gig linecard

[Michiel Muhlenbaumer]

First run 'no module blabla' and then power-off/on the lc.

Met vriendelijke groet,
Best regards,

Michiel Muhlenbaumer
Atrato IP Networks

(sent from mobile device)

On 9 nov. 2010, at 16:58, Remco Bressers <remco at signet.nl> wrote:

> Hi,
> 
> The other day, i inserted a brand new NI-XMR-10Gx4 in an XMR-4, but it
> won't work correctly.
> If i do a "show module", i see the following output on the slot :
> 
> S2: NI-XMR-10Gx4 4-port 10GbE Module  CARD_STATE_INTERACTIVE    20
> 0012.f2f5.d128
> (S2: Configured as NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module)
> 
> What is the correct procedure to configure S2 as ni-xmr-10gx4 ?
> 
> I tried :
> 
> telnet at r(config)#module 2 ni-xmr-4-port-10g
> Error: Please remove module from slot 2 first
> telnet at r(config)#
> 
> Is this the only (and correct) way?
> 
> -- 
> Kind regards,
> Signet bv
> 
> Remco Bressers
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp