[f-nsp] Not able to use XMR 10 gig linecard

[Remco Bressers]

Unfortunately that won't work because of the same reason :

telnet at ams-er8-sara(config)#no module 2 ni-xmr-20-port-1g
Error: Please remove module from slot 2 first

Also, powering off the card won't do.

:(

Regards,

Remco


On 11/09/2010 05:12 PM, Michiel Muhlenbaumer wrote:
> First run 'no module blabla' and then power-off/on the lc.
> 
> Met vriendelijke groet,
> Best regards,
> 
> Michiel Muhlenbaumer
> Atrato IP Networks
> 
> (sent from mobile device)
> 
> On 9 nov. 2010, at 16:58, Remco Bressers <remco at signet.nl> wrote:
> 
>> Hi,
>>
>> The other day, i inserted a brand new NI-XMR-10Gx4 in an XMR-4, but it
>> won't work correctly.
>> If i do a "show module", i see the following output on the slot :
>>
>> S2: NI-XMR-10Gx4 4-port 10GbE Module  CARD_STATE_INTERACTIVE    20
>> 0012.f2f5.d128
>> (S2: Configured as NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module)
>>
>> What is the correct procedure to configure S2 as ni-xmr-10gx4 ?
>>
>> I tried :
>>
>> telnet at r(config)#module 2 ni-xmr-4-port-10g
>> Error: Please remove module from slot 2 first
>> telnet at r(config)#
>>
>> Is this the only (and correct) way?
>>
>> -- 
>> Kind regards,
>> Signet bv
>>
>> Remco Bressers
>> _______________________________________________
>> foundry-nsp mailing list
>> foundry-nsp at puck.nether.net
>> http://puck.nether.net/mailman/listinfo/foundry-nsp


-- 
Met vriendelijke groet,
Signet bv


Remco Bressers

T 040 - 707 4 907
F 040 - 707 4 909
E rbressers at signet.nl
altijd online? www.signet.nl