[f-nsp] Link Aggregation between Foundry and Cisco

[Scott T. Cameron]

On Fri, Jan 7, 2011 at 7:27 PM, Joseph Hardeman <jwhardeman at gmail.com>wrote:

> Hi Everyone,
>
> I am having a bit of an issue, I have gotten a pair of Cisco 6509's with
> the SUP-720 engines.  I am trying to configure link aggregation between one
> of these to a BI4000 I have to test with before we put them into production
> and connect them to our BI8000's and fight this problem then.  I have been
> searching and looking at the docs I have.  The configuration I have on the
> Cisco's allow them to talk over the port channels between each other with no
> issues.
>
> I can setup the command "link-aggregation active" on port "ethe 1/5" with
> no issues it takes the command, but when I go to add a test VLAN on to that
> port I get the following error message:
>
> error - some ports are running LACP and can not be tagged ports.
>
> Here is the command I am running on the BI:
>
> test(config)#int e 1/5
> test(config-if-e1000-1/5)#link-aggregate configure key 10000
> test(config-if-e1000-1/5)#link-aggregate active
> test(config-if-e1000-1/5)#exit
> test(config)#vlan 14
> test(config-vlan-14)#tagged e 1/5
> error - some ports are running LACP and can not be tagged ports.
>

I run this very config on FESX648 to Catalyst and SuperX to Catalyst without
any problems.  Are you running ancient code?

Scott
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20110107/544bb1a5/attachment.html>