[f-nsp] NI-MLX-10Gx4 shown as "Invalid Module" maybe due to very old code on lp whlile chassis is on 5.3

[Erich Hohermuth]

Hi Gunther,

Out of curiosity, cause I had a similar case. Was another LP in the 
same slot before ? Cause if you remove a card, the config is still in 
place and you have to remove the module in the config before you 
re-insert a different card.

Regards
 Erich

Am Wed Jul 24 23:28:49 2013 schrieb Gunther Stammwitz:
> Hi Niels,
>
> upgrading boot+monitor+lp image is exactly what I want.
> The problem is that it doesn't work most probably because the mp cannot
> communicate with lp and lp stays ins "CARD_STATE_REBOOT"
>
> #Show module
> S4: Invalid Module  CARD_STATE_REBOOT   0        000c.dbe1.2f90
> --> no success
>