[f-nsp] NI-XMR-10GX4 linecard doesn't boot.

Carlos Alfaro Carlos at townsendnetworks.com
Fri Sep 5 20:19:25 EDT 2014


 I have NI-XMR-10GX4 linecard doesn't boot properly  " CARD_STATE_SW_LOADED" after issue the command : lp boot sys mp pri 4 the unit boot into interactive mode, Then powercycle the 
linecard with a power-off and power-on does not work. the rconsole 4 mode display the correct code, the diag burn-in does not detect any problem. 

Does anyone have experience with this issue?  

Any advice would be helpful.

Thanks
 

*************************************************************************************************

NetIron XMR-4000 Router#show mod
Module                                                      Status                       Ports    Starting MAC
M1 (left ):NI-XMR-MR Management Module                      Active
M2 (right):
F1: NI-X-SF  Switch Fabric Module                           Active
F2: NI-X-SF  Switch Fabric Module                           Active
F3:
S1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module              CARD_STATE_UP                20       0012.f294.3000
S2: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module              CARD_STATE_UP                20       0012.f294.3030
S3:
S4: NI-XMR-10Gx4 4-port 10GbE Module                        CARD_STATE_SW_LOADED         0        0012.f294.3090
NetIron XMR-4000 Router#
NetIron XMR-4000 Router#
NetIron XMR-4000 Router#
NetIron XMR-4000 Router#show ver
System Mode: XMR
Chassis: NetIron 4-slot (Serial #: SA03085047,  Part #: 35550-000B)
NI-X-SF  Switch Fabric Module 1 (Serial #: SA05081009,  Part #: 35548-101A)
FE 1: Type fe200,  Version 2
Switch Fabric Module 1 Up Time is 4 minutes 13 seconds
NI-X-SF  Switch Fabric Module 2 (Serial #: SA05081108,  Part #: 35548-101A)
FE 1: Type fe200,  Version 2
Switch Fabric Module 2 Up Time is 4 minutes 13 seconds
==========================================================================
SL M1: NI-XMR-MR Management Module Active (Serial #: SA07080608, Part #:    35524-502A):
Boot     : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:42:38 labeled as xmprm05600
 (516258 bytes) from boot flash
Monitor  : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:41:56 labeled as xmb05600
 (534157 bytes) from code flash
IronWare : Version 5.6.0dT163 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Jul 24 2014 at 22:51:20 labeled as xmr05600d
 (9442445 bytes) from Primary
Board ID : 00 MBRIDGE Revision : 37
916 MHz Power PC processor 7447A (version 8003/0101) 166 MHz bus
512 KB Boot Flash (AM29LV040B), 32 MB Code Flash (MT28F128J3)
2048 MB DRAM INSTALLED
--More--, next page: Space, next line: Return key, quit: Control-cSlot 4 is powered off.
2048 MB DRAM ADDRESSABLE
Active Management uptime is 4 minutes 13 seconds
==========================================================================
SL 1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module (Serial #: SA03082318, Part #: 35570-202A)
Boot     : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:43:00 labeled as xmlprm05600
 (423373 bytes) from boot flash
Monitor  : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:43:26 labeled as xmlb05600
 (539767 bytes) from code flash
IronWare : Version 5.6.0dT177 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Jul 24 2014 at 22:57:38 labeled as xmlp05600d
 (7492178 bytes) from Primary
FPGA versions:
Valid PBIF Version = 4.02, Build Time = 8/26/2013 14:30:00

Valid XPP Version = 1.01, Build Time = 9/6/2013 14:17:00

BCM5695GMAC 0
BCM5695GMAC 1
666 MHz MPC 8541 (version 8020/0020) 333 MHz bus
512 KB Boot Flash (AM29LV040B), 16 MB Code Flash (MT28F640J3)
1024 MB DRAM, 8 KB SRAM, 286331153 Bytes BRAM
--More--, next page: Space, next line: Return key, quit: Control-cSlot 4 is powering on.
LP Slot 1 uptime is 3 minutes 36 seconds
==========================================================================
SL 2: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module (Serial #: SA03082271, Part #: 35570-202A)
Boot     : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:43:00 labeled as xmlprm05600
 (423373 bytes) from boot flash
Monitor  : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:43:26 labeled as xmlb05600
 (539767 bytes) from code flash
IronWare : Version 5.6.0dT177 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Jul 24 2014 at 22:57:38 labeled as xmlp05600d
 (7492178 bytes) from Primary
FPGA versions:
Valid PBIF Version = 4.02, Build Time = 8/26/2013 14:30:00

Valid XPP Version = 1.01, Build Time = 9/6/2013 14:17:00

BCM5695GMAC 0
BCM5695GMAC 1
666 MHz MPC 8541 (version 8020/0020) 333 MHz bus
512 KB Boot Flash (AM29LV040B), 16 MB Code Flash (MT28F640J3)
1024 MB DRAM, 8 KB SRAM, 286331153 Bytes BRAM
LP Slot 2 uptime is 3 minutes 39 seconds
==========================================================================
All show version done

  ******  Rconsole **********
LP-4 Monitor>show ver
  Boot     05.06.00T175     Sep 20 2013 16:43:00 PDT xmlprm05600
  Monitor  05.06.00T175     Sep 20 2013 16:43:26 PDT xmlb05600 (code)
  666 MHz Power PC processor MPC8541E (version 8020/0020) 333.3335 MHz bus
  started=crashed
LP-4 Monitor>show flash
Boot Flash Memory  : AM29LV040B
  Manufacture Code : 01
  Device Code      : 4f
Code Flash Memory  : MT28F640J3
  Manufacture Code : 89
  Device Code      : 17
  Erase Count      : 0
LP-4 Monitor>show


Carlos Alfaro  

Tech / Sales Support

Townsend Networks

35 Reed Blvd., Suite A  Mill Valley, CA 94941                    

415-384-4208 

mailto:carlos at townsendnetworks.com


More information about the foundry-nsp mailing list