[f-nsp] NI-XMR-10GX4 linecard doesn't boot.

Mike Tindle mtindle at he.net
Fri Sep 5 20:35:29 EDT 2014


Try putting the card into interactive mode and then loading the 5.6 FPGAs on it.  Then power cycle the card and try booting again.  

I’ve seen cards occasionally do this if their FPGA code is too far out of version sync with the boot/mon/NetIron version running. 

Regards,
Mike


On Sep 5, 2014, at 5:19 PM, Carlos Alfaro <Carlos at townsendnetworks.com> wrote:

> 
> I have NI-XMR-10GX4 linecard doesn't boot properly  " CARD_STATE_SW_LOADED" after issue the command : lp boot sys mp pri 4 the unit boot into interactive mode, Then powercycle the 
> linecard with a power-off and power-on does not work. the rconsole 4 mode display the correct code, the diag burn-in does not detect any problem. 
> 
> Does anyone have experience with this issue?  
> 
> Any advice would be helpful.
> 
> Thanks
> 
> 
> *************************************************************************************************
> 
> NetIron XMR-4000 Router#show mod
> Module                                                      Status                       Ports    Starting MAC
> M1 (left ):NI-XMR-MR Management Module                      Active
> M2 (right):
> F1: NI-X-SF  Switch Fabric Module                           Active
> F2: NI-X-SF  Switch Fabric Module                           Active
> F3:
> S1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module              CARD_STATE_UP                20       0012.f294.3000
> S2: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module              CARD_STATE_UP                20       0012.f294.3030
> S3:
> S4: NI-XMR-10Gx4 4-port 10GbE Module                        CARD_STATE_SW_LOADED         0        0012.f294.3090
> NetIron XMR-4000 Router#
> NetIron XMR-4000 Router#
> NetIron XMR-4000 Router#
> NetIron XMR-4000 Router#show ver
> System Mode: XMR
> Chassis: NetIron 4-slot (Serial #: SA03085047,  Part #: 35550-000B)
> NI-X-SF  Switch Fabric Module 1 (Serial #: SA05081009,  Part #: 35548-101A)
> FE 1: Type fe200,  Version 2
> Switch Fabric Module 1 Up Time is 4 minutes 13 seconds
> NI-X-SF  Switch Fabric Module 2 (Serial #: SA05081108,  Part #: 35548-101A)
> FE 1: Type fe200,  Version 2
> Switch Fabric Module 2 Up Time is 4 minutes 13 seconds
> ==========================================================================
> SL M1: NI-XMR-MR Management Module Active (Serial #: SA07080608, Part #:    35524-502A):
> Boot     : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Sep 20 2013 at 16:42:38 labeled as xmprm05600
> (516258 bytes) from boot flash
> Monitor  : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Sep 20 2013 at 16:41:56 labeled as xmb05600
> (534157 bytes) from code flash
> IronWare : Version 5.6.0dT163 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Jul 24 2014 at 22:51:20 labeled as xmr05600d
> (9442445 bytes) from Primary
> Board ID : 00 MBRIDGE Revision : 37
> 916 MHz Power PC processor 7447A (version 8003/0101) 166 MHz bus
> 512 KB Boot Flash (AM29LV040B), 32 MB Code Flash (MT28F128J3)
> 2048 MB DRAM INSTALLED
> --More--, next page: Space, next line: Return key, quit: Control-cSlot 4 is powered off.
> 2048 MB DRAM ADDRESSABLE
> Active Management uptime is 4 minutes 13 seconds
> ==========================================================================
> SL 1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module (Serial #: SA03082318, Part #: 35570-202A)
> Boot     : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Sep 20 2013 at 16:43:00 labeled as xmlprm05600
> (423373 bytes) from boot flash
> Monitor  : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Sep 20 2013 at 16:43:26 labeled as xmlb05600
> (539767 bytes) from code flash
> IronWare : Version 5.6.0dT177 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Jul 24 2014 at 22:57:38 labeled as xmlp05600d
> (7492178 bytes) from Primary
> FPGA versions:
> Valid PBIF Version = 4.02, Build Time = 8/26/2013 14:30:00
> 
> Valid XPP Version = 1.01, Build Time = 9/6/2013 14:17:00
> 
> BCM5695GMAC 0
> BCM5695GMAC 1
> 666 MHz MPC 8541 (version 8020/0020) 333 MHz bus
> 512 KB Boot Flash (AM29LV040B), 16 MB Code Flash (MT28F640J3)
> 1024 MB DRAM, 8 KB SRAM, 286331153 Bytes BRAM
> --More--, next page: Space, next line: Return key, quit: Control-cSlot 4 is powering on.
> LP Slot 1 uptime is 3 minutes 36 seconds
> ==========================================================================
> SL 2: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module (Serial #: SA03082271, Part #: 35570-202A)
> Boot     : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Sep 20 2013 at 16:43:00 labeled as xmlprm05600
> (423373 bytes) from boot flash
> Monitor  : Version 5.6.0T175 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Sep 20 2013 at 16:43:26 labeled as xmlb05600
> (539767 bytes) from code flash
> IronWare : Version 5.6.0dT177 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
> Compiled on Jul 24 2014 at 22:57:38 labeled as xmlp05600d
> (7492178 bytes) from Primary
> FPGA versions:
> Valid PBIF Version = 4.02, Build Time = 8/26/2013 14:30:00
> 
> Valid XPP Version = 1.01, Build Time = 9/6/2013 14:17:00
> 
> BCM5695GMAC 0
> BCM5695GMAC 1
> 666 MHz MPC 8541 (version 8020/0020) 333 MHz bus
> 512 KB Boot Flash (AM29LV040B), 16 MB Code Flash (MT28F640J3)
> 1024 MB DRAM, 8 KB SRAM, 286331153 Bytes BRAM
> LP Slot 2 uptime is 3 minutes 39 seconds
> ==========================================================================
> All show version done
> 
>  ******  Rconsole **********
> LP-4 Monitor>show ver
>  Boot     05.06.00T175     Sep 20 2013 16:43:00 PDT xmlprm05600
>  Monitor  05.06.00T175     Sep 20 2013 16:43:26 PDT xmlb05600 (code)
>  666 MHz Power PC processor MPC8541E (version 8020/0020) 333.3335 MHz bus
>  started=crashed
> LP-4 Monitor>show flash
> Boot Flash Memory  : AM29LV040B
>  Manufacture Code : 01
>  Device Code      : 4f
> Code Flash Memory  : MT28F640J3
>  Manufacture Code : 89
>  Device Code      : 17
>  Erase Count      : 0
> LP-4 Monitor>show
> 
> 
> Carlos Alfaro  
> 
> Tech / Sales Support
> 
> Townsend Networks
> 
> 35 Reed Blvd., Suite A  Mill Valley, CA 94941                    
> 
> 415-384-4208 
> 
> mailto:carlos at townsendnetworks.com
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp

*----------- H U R R I C A N E - E L E C T R I C ---------->>
| Mike Tindle | Senior Network Engineer | mtindle at he.net
| ASN 6939 | http://www.he.net | 510-580-4126
*--------------------------------------------------->>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20140905/69d6a461/attachment.html>


More information about the foundry-nsp mailing list