[f-nsp] Showing optical values on FastIron 07.3.00h

[Tim Warnock]

What does a show media look like?

A looped on itself? B the wrong port?

> -----Original Message-----
> From: foundry-nsp [mailto:foundry-nsp-bounces at puck.nether.net] On
> Behalf Of Jörg Kost
> Sent: Tuesday, 8 October 2019 7:07 PM
> To: foundry-nsp <foundry-nsp at puck.nether.net>
> Subject: [f-nsp] Showing optical values on FastIron 07.3.00h
> 
> Hello,
> 
> is there any "hidden" command e.g. on 07.3.00h for printing out optical
> values, when a link is not fully connected?
> 
> For example, using the same vendor optic between sites A and B, B shows
> no TX,RX at all.
> 
> A:
> 
> # show optic 11
> Port  Temperature   Tx Power     Rx Power     Tx Bias Current
> +----+-----------+----------+------------+-------------------+
> 11   52.3906 C   000.8022 dBm -011.5676 dBm   30.178 mA
> Normal       Normal        Normal      Normal
> 
> # show interfaces ethernet 11 | include up
> 10GigabitEthernet11 is up, line protocol is up
> Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, actual
> fdx
> 
> But site B:
> 
> # show interfaces ethernet 11 | include line
> 10GigabitEthernet11 is down, line protocol is down
> 
> #show optic 11
> # (empty line)
> 
> Regards
> 
> Jörg
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp