sb200

[Jack Schrader]

I have finally gotten my sb200 to work after installing the Harbach soft start and power modules. Everything is working ok except on 40m and its output is low, but that is another story.

Meter reading are ok except  for plate current and it does not move on any of the bands. Any ideas what I should look at that might cause this problem? I can't figure out what is connected in the plate position.

Thanks

Jack

-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved.  This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind.  Buyer beware!

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.aspx?list=HEATH
To post - HEATH at LISTS.TEMPE.GOV
Archives - http://lists.tempe.gov/archives/HEATH.html