[Heath] HW100 IF voltages

[G3OOU at aol.com]

Hi Dick
 
I am slightly puzzled by your results. When I connected my SB-610 Monitor  
to my SB101 all I had to do was retune the IF anode circuit to compensate 
for  the extra capacitive load and the receiver returned to its original 
output level  as long as the coax connection was left in place. What value signal 
coupling  capacitor did you use? I recall that I used a 10pF or similar low 
value.
 
The screen resistor change to 10K does reduce the IF tube dissipation a bit 
 and it also makes a slight improvement to the AGC characteristics since 
the 6AU6  is a sharp cutoff tube and not really intended for AGC operation.
 
73

Bob

Bob F Burns
C Eng,  FIET, MSE
Amateur Radio Callsign: G3OOU
Registered RSGB  Instructor
G-QRP Member No: 6907; Zone: 14, QRA: IO91WH; WAB:  TQ25
Secretary of Crystal Palace Radio & Electronics Club: _www.g3oou.co.uk_ 
(http://www.g3oou.co.uk/) 
Technical web site: _www.qsl.net/g3oou_ (http://www.qsl.net/g3oou) 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/heath/attachments/20120605/b9c9d167/attachment.html>