[j-nsp] ISIS overload bit settings

Umar.Ahmed at equinoxsolutions.com Umar.Ahmed at equinoxsolutions.com
Mon Sep 29 16:13:29 EDT 2003


I thought on-startup was only supported by the erx series routers ?

-----Original Message-----
From: Daniel Roesen
To: juniper-nsp at puck.nether.net
Sent: 29/09/2003 17:23
Subject: Re: [j-nsp] ISIS overload bit settings

On Mon, Sep 29, 2003 at 06:21:18PM +0200, Daniel Roesen wrote:
> On Mon, Sep 29, 2003 at 12:15:45PM +0100,
Umar.Ahmed at equinoxsolutions.com wrote:
> > Just trawled through the Juniper website trying to find out if JunOS
> > supports anything similar to the "on-startup" or "wait-for-bgp"
> > This makes IS-IS wait for BGP to converge before clearing the
overload bit.
> Doesn't exist (sadly).

Sorry, I have to clarify: something like "on-startup" exists
as "set protocols isis overload [timeout <seconds>]". But there is
nothing which watches for BGP keepalives in order to have a heuristic
for "BGP converged".

Best regards,
juniper-nsp mailing list juniper-nsp at puck.nether.net

Equinox Converged Solutions Limited.
Tel: +44 (0)1252 405 600

This message is intended solely for the use of the Individual or organisation to whom it is addressed. It may contain privileged or confidential information.  If you have received this message in error, please notify the originator immediately.
If you are not the intended recipient, you should not use, copy, alter, or disclose the contents of this message.  All information or opinions expressed in this message and/or any attachments are those of the author and are not necessarily those of Equinox Converged Solutions Limited.
Equinox Converged Solutions Limited accepts no responsibility  for loss or damage arising from its use, including damage from virus.

More information about the juniper-nsp mailing list