[j-nsp] Flapping GE Module causing FEB to reboot

[Joerg Staedele / Trusted Network]

Josef Buchsteiner wrote:
> Joerg,
>       trust Pekka he was right spot on. Don't run diagnostic on the
>       box just like that. You have to do much command before results
>       are meaning full. So get in contact with jtac and they will
>       provide you with a solution to your problem.
> 
>       josef

Josef,

i did the following:

- bringup chassis slot-state 0 diag
- diagnostic set mode manufacturing
- diag clear log
- diag cchip sramtest

After the last command, the sramtest was started and some seconds later
i got disconnected from the FEB and wasn't able to reconnect to the FEB
(Connection refused) .. after some time i was able to get in again and
saw that the FEB rebooted itself.

Maybe there was a problem since the router was still in production (but
i was logged in via Serial Console).

What's the best way to get it "down" to do all this diagnostic things?
Do i have to deactivate all config things?

Best regards,

 Joerg