[j-nsp] Juniper M40e - cpu and memory command

[Hannes Gredler]

vinay,

you can display the CPU load of the FPCs
using the <show chassis fpc> command.

the channelized OC3 PIC does not have a dedicated
control-board where you could measure CPU load.

anyway, since the OC3 PIC is ASIC based you will not
see a performance drop, irrespective of
offered load.

/hannes

vinay pit wrote:
> Dear All
> 
> I am using Juniper M40e for my scenario and i have to
> find the stability of the Ch OC3 PIC 
> 
> The FPC is 7
> and the PIC is 0 , these are the slot
> specifications...
> 
> 
> I have to find the cpu and memory used...
> 
> I can see the cpu and the memory of the routing engine
> by using the command 
> 
> show chassis routing-engine 1
> 
> but is there any command to see cpu and memory related
> to the FPC or the PIC ?
> 
> If any command is there related to FPC or PIC then
> please let me know the same.
> 
> 
> Regards
> Vinay
> 
> 
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/juniper-nsp