[j-nsp] VPLS tunnel LSP establishment

[Tomasz Szewczyk]

Hi,

In my opinion it is much better to use router ID (loopback). You can 
experience some problems when using interface address if it goes down. I 
assume you have redundant connections/paths between PE1 and PE2.

Regards,

Tomek

Monika M pisze:
> site1---PE1 ----- P1-----------P2-----------(x)-PE2----site2
>
> I have BGP peering between PE1-PE2 for having L2VPN service.
> L2VPN configuration steps mandate configuration of tunnel LSP establishment.
> Should I have an LSP for the PE2's interface address x or PE2's router ID.
>
> TIA
> Monika
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
>   


-- 
Tomasz Szewczyk
Poznan Supercomputing and Networking Center
e-mail: tomeks at man.poznan.pl

fax: +48 61 8525954