[j-nsp] L2circuit local-switching

[Jonas Frey]

Hi Alexander,

doesnt work:

Connection/Circuit Type St Time last up     # Up trans
test   if-sw       Dn      -----       0
  ae0.28                            intf  NP
  ge-1/1/0.3                        intf  NP

jonas at ffm3-edge# show protocols connections 
interface-switch test {
    interface ae0.28;
    interface ge-1/1/0.3;
}

Still hardware not present...do you need a special encapsulation or is
there any hardware limitation? (Do you need to use VLAN's with ids >512
because of vlan-ccc?)


Regards,
Jonas Frey

On Thu, 2007-05-10 at 22:36, Alexander Koch wrote:
> Jonas,
> 
> try proto connections. If it works, be happy. :)
> Been there, did that, just did the same, but
> actually worked.
> 
> -ako
> 
> On Thu, 10 May 2007 14:27:53 +0200, Jonas Frey wrote:
> > Hello,
> > 
> > i am trying to configure local-switching via l2circuits.
> > Config is pretty straight-forward:
> > 
> > local-switching {
> >     interface ae0.28 {
> >         end-interface {
> >             interface ge-1/1/0.3;
> >         }
> > (both interfaces are vlan tagged with the same vlan)
> > 
> > However this doesnt work. Via show l2circuit connections i get:
> >  Local Switch ae0.28 
> >     Interface                 Type  St     Time last up          # Up
> > trans
> >     ae0.28(vc 0)              rmt   NP   
> > 
> > NP seems to be h/w not present. But the interfaces are there...isnt it
> > possible to switch subinterfaces and/or vlan-tagged interfaces?
> > 
> > Regards,
> > Jonas Frey