[j-nsp] frame-relay J6350 to Cisco 2611
BRIANT Alain
alain.briant at c-s.fr
Wed Sep 12 12:56:45 EDT 2007
Hi Ivan
here is a starting config assuming you are on the serial 1/0/0
lab at toto# show interfaces
se-1/0/0 {
dce;
encapsulation frame-relay;
serial-options {
clock-rate 2.048mhz;
}
unit 0 {
dlci 199;
family inet {
address 192.168.1.1/30;
}
}
}
You will need the starting "serial-option and clock-rate" only if you
have a DCE cable (female one and male on the cisco side)
In the contrary you will need to remove it.
The DCE statement should be needed as you have a DTE behavior by default
on the cisco side.
I'm not sure it will disturb but I would advise you to test first
without the "crypto map IPSec-con" statement on the cisco side
You will normaly be able to ping from one side to the other one
Good tests
regards
Alain
Ivan c a écrit :
>Hi All,
>
>Looking for a little help with a frame-relay connection between a
>Cisco 2611 and a Juniper J6350.
>
>This is the serial interface on the J6350, which I hope can play
>frame-relay with IETF?
>http://www.juniper.net/products/jseries/dsheet/100116.pdf
>
>
>This is the Cisco 2611 side of the equation, which is currently
>working to a Cisco 7206 which is getting swapped out for the J6350
>
>interface Serial0/0
> mtu 1550
> no ip address
> encapsulation frame-relay IETF
> load-interval 30
> no fair-queue
> frame-relay traffic-shaping
>!
>interface Serial0/0.199 point-to-point
> ip address 192.168.1.2 255.255.255.252
> frame-relay interface-dlci 199
> crypto map IPSec-con
>
>any ideas for the Juniper side of the equation would be much appreciated.
>
>thanks
>Ivan
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/juniper-nsp
>
>
>
>
More information about the juniper-nsp
mailing list