[j-nsp] monitor interface rate

[harbor235]

Thanx all for your input, I found out that OVPI can do the calc for me in
HPOV.
Also, the other methods discussed were also of great interest.

thanx,

Mike

On Fri, Aug 14, 2009 at 4:07 PM, Alex <alex.arseniev at gmail.com> wrote:

> Apart from using Cacti/HPOV capabilities to calculate % usage, etc you
> could do this by writing an event-script that takes interface stats, does
> some trivial math and populates Utility MIB (jnxUtil).
> Rgds
> Alex
>
> ----- Original Message ----- From: "harbor235" <harbor235 at gmail.com>
> To: <juniper-nsp at puck.nether.net>
> Sent: Thursday, August 13, 2009 2:06 PM
> Subject: [j-nsp] monitor interface rate
>
>
>  To all,
>>
>> I would like to monitor a juniper router interface via snmp, simple
>> enough.
>> However, I do not want bps, I want to monitor the interface as a
>> percentage
>> of it's total capacity. In the end I want to be notified if my interface
>> exceeds 70%
>> of capacity so I can initiate capacity management planning.
>>
>> I know I can on an interface by interface basis figure out 70% and program
>> that into
>> each interface collection, however, that does not scale. Is there anyone
>> out
>> there
>> that knows of a MIB obect that does this?
>>
>> thanx,
>>
>> Mike
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>
>>
>