[j-nsp] No Reflector-Client Command Supporte

[Olof Kasselstrand]

Have a look at http://www.juniper.net/techpubs/software/junos-es/junos-es92/junos-es-swconfig-interfaces-and-routing/configuring-a-route-reflector-optional.html

// Olof

On Wed, Oct 7, 2009 at 7:30 AM, a.r.isnaini.rangkayo.st
<risnaini at netsoft.net.id> wrote:
> Hallo,
>
>
> I'm trying to simply re-advertise some prefixes in a 3 iBGP speakers serial
> topology.
> Second router [in the middle] should set both 1rst & 3rd routers as
> reflector client.
> Does the process just simply add this command in second router ?.
>
> If so then, I didn't see that my engine supports this command.
> Or I missed another pre-step to have this command to appear.
>
> Thanks in Advance
> a. rahman isnaini r.sutan
>
>
> # set neighbor 192.168.24.109 ?
> Possible completions:
>  <[Enter]>            Execute this command
>  advertise-inactive   Advertise inactive routes
>  advertise-peer-as    Advertise routes received from the same autonomous
> system
> + apply-groups         Groups from which to inherit configuration data
> + apply-groups-except  Don't inherit configuration data from these groups
>  as-override          Replace neighbor AS number with our AS number
>  authentication-key   MD5 authentication key
>  cluster              Cluster identifier
>  damping              Enable route flap damping
>  description          Text description
> + export               Export policy
>> family               Protocol family for NLRIs in updates
>> graceful-restart     BGP graceful restart options
>  hold-time            Hold time used when negotiating with a peer (6..65535)
> + import               Import policy
>  include-mp-next-hop  Include NEXT-HOP attribute in multiprotocol updates
>  ipsec-sa             IPSec SA name
>  keep                 How to retain routes in the routing table
>  local-address        Address of local end of BGP session
>> local-as             Local autonomous system number
>  local-interface      Local interface for IPv6 link local EBGP peering
>  local-preference     Value of LOCAL_PREF path attribute
>  log-updown           Log a message for peer state transitions
>> metric-out           Route metric sent in MED
>  mtu-discovery        Enable TCP path MTU discovery
>> multihop             Configure an EBGP multihop session
>  multipath            Allow load sharing among multiple BGP paths
>  no-advertise-peer-as  Don't advertise routes received from the same
> autonomous system
>  no-aggregator-id     Set router ID in aggregator path attribute to 0
>  no-client-reflect    Disable intracluster route redistribution
>  out-delay            How long before exporting routes from routing table
>  passive              Do not send open messages to a peer
>  peer-as              Peer autonomous system number (1..65535)
>  preference           Preference value
>  remove-private       Remove well-known private AS numbers
>> traceoptions         Trace options for BGP
>  vpn-apply-export     Apply BGP export policy when exporting VPN routes
>  |                    Pipe through a command
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>