[j-nsp] Juniper MX80 IRB

[Addy Mathur]

On Wednesday, July 28, 2010, Mark Tinka <mtinka at globaltransit.net> wrote:
> On Tuesday, July 27, 2010 10:31:18 pm Chuck Anderson wrote:
>
>> Finally, JTAC/ATAC can't even figure out the above!!!  I
>> have a case open and they *still* haven't come to the
>> solution because they haven't realized that "Today Trio
>> only supports the old style config" and what that really
>> means.
>
> The disconnect between JTAC and the core of the development
> team has always been there, in my opinion. It took a whole
> year of back-and-forth with JTAC on a case that, when it was
> finally escalated to a senior engineer within Juniper, was
> resolved in 30 minutes. No, seriously...
>
> It's easy to assume that just because JTAC work for Juniper,
> they're familiar with JUNOS and the Juniper hardware. But
> this, as I've seen time & time again, really isn't the case.
>
> Mark.
>

Although it doesn't answer the specific question raised via this
thread, the following link dose offer some general guidance on Trio
chipset features.  Should mostly be applicable to the MX80 as well.

http://www.juniper.net/techpubs/en_US/release-independent/junos/topics/reference/general/mpc-mx-series-features.html

Regards,
Addy.