[j-nsp] IPv6 on LAG Bundles - Juniper E-Series

[Callum Barr]

Hi All,

 

Do any of you know if it is possible to run IPv6 over a LAG bundle on an E320?

 

Whenever I try to configure anything to do with IPv6 on a lag interface I get the following;

 

t-rex:lab(config-if)#ipv6 address xxxx:xxxx:dead:beef::1/64

% lower layer bind failed

 

Is this expected behavior?  It seems rather retarded if v6 isnt supported on a lag bundle, but it is supported on pretty much every other interface under the sun.

 

Cheers,

 

Callum Barr

Network Engineer

worldxChange Communications

 

@: cbarr at wxc.co.nz