[j-nsp] Output for "show bgp summary" is showing different on twoREs

[saurabh sood]

It will help me to narrowdown this issue.

Thanks

On Sat, Jun 25, 2011 at 9:23 PM, Alex <alex.arseniev at gmail.com> wrote:

> If the BGP peer in the master Routing Engine has negotiated address-family
> capabilities that are not supported for nonstop active routing, then the
> corresponding BGP neighbor state on the backup Routing Engine shows as idle.
> On switchover, the BGP session is reestablished from the new master Routing
> Engine.
> http://www.juniper.net/**techpubs/en_US/junos11.1/**
> topics/reference/requirements/**nsr-system-requirements.html#**nsr-bgp<http://www.juniper.net/techpubs/en_US/junos11.1/topics/reference/requirements/nsr-system-requirements.html#nsr-bgp>
> Note, for instance, inet-vpn multicast AFI is not supported for NSR.
> HTH
> Rgds
> Alex
>
>
> ----- Original Message ----- From: "saurabh sood" <saurabh24u at gmail.com>
> To: <juniper-nsp at puck.nether.net>
> Sent: Saturday, June 25, 2011 2:40 PM
> Subject: [j-nsp] Output for "show bgp summary" is showing different on
> twoREs
>
>
>  Hello,
>>
>> I have observed a different scenario, i don't know wthr it is by expected
>> or
>> not.
>>
>> Router has two REs and GRES, NSR is enabled also commit synchronize is
>> there.
>> But while checking the output for "show bgp summary" then on Master RE
>> everything is showing ok.
>>
>> On the other hand backup RE is showing all bgp states IDLE.
>>
>> Is it an expected behavior?
>>
>> Regards,
>>
>> Sunny
>> ______________________________**_________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/**mailman/listinfo/juniper-nsp<https://puck.nether.net/mailman/listinfo/juniper-nsp>
>>
>>
>