[j-nsp] SSH/Telnet session hanging

OBrien, Will ObrienH at missouri.edu
Tue May 31 16:28:50 EDT 2011


Haven't had that issue, but you can get around it.

Just run the command and pipe it to a file. Then you can scp it off.

show config | save filename
start shell
scp filename user at server:/path

Will


On May 31, 2011, at 3:18 PM, Muhammad Adnan Mohsin wrote:

> Hi Experts,
> I have a MX240 router installed at a remote location. I am able to
> telnet/SSH the router but when I run a command that needs to return a
> large output (e.g. show log messages or show conf) the session hangs
> and then I have to re-establish the connection. Because of this I
> couldn't provide some outputs that were required by JTAC. As long as
> the commands I give on the router don't have to return a large output,
> the session remains intact. The current code that I am running is
> 10.2R3.10. JTAC has recommended me to install 10.3R2 but I have a
> feeling that won't work. Has somebody experience a similar issue? I
> would appreciate if somebody could give me some guidance to
> troubleshoot this problem.
> 
> thanks.
> Adnan.
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp

Will O'Brien
University of Missouri, DoIT DNPS
Network Systems Analyst - Redacted

obrienh at missouri.edu






More information about the juniper-nsp mailing list