[j-nsp] Unfamiliar with Juniper M10 Config Files

[Joel jaeggli]

the show bgp neighbor (neighborip)

on the juniper will tell you how many it's sending. e.g. an example
session...

    Active prefixes:              64903
    Received prefixes:            374540
    Accepted prefixes:            374538
    Suppressed due to damping:    0
    Advertised prefixes:          3

On 10/21/11 09:15 , Loopback EZ wrote:
> I am replacing an old Cisco router with a Brocade MLX as IBGP peer to a
> Juniper M10.  I am only getting 250K routes and I have NO filtering
> enabled.  I know that the Juniper is receiving a full EBGP route table
> but is only passing 250K to any of its internal IBGP peers including the
> old Cisco.  Suspect that there is route summarization happening so it
> would not overrun an old Cisco SUP module.  Where should I look for
> summarization or any other possible cause in the Juniper config?
> 
> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>