[j-nsp] Unfamiliar with Juniper M10 Config Files

[Alex]

I am not sure about exact Brocade command,
but do you have BGP "prefix-limit" enabled on Brocade? 
Rgds
Alex

----- Original Message ----- 
From: "Loopback EZ" <loopback at ezxyz.com>
To: <juniper-nsp at puck.nether.net>
Sent: Friday, October 21, 2011 5:15 PM
Subject: [j-nsp] Unfamiliar with Juniper M10 Config Files


>I am replacing an old Cisco router with a Brocade MLX as IBGP peer to a 
> Juniper M10.  I am only getting 250K routes and I have NO filtering 
> enabled.  I know that the Juniper is receiving a full EBGP route table 
> but is only passing 250K to any of its internal IBGP peers including the 
> old Cisco.  Suspect that there is route summarization happening so it 
> would not overrun an old Cisco SUP module.  Where should I look for 
> summarization or any other possible cause in the Juniper config?
> 
> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>