[j-nsp] Unfamiliar with Juniper M10 Config Files

[Doug Hanks]

show route advertising-protocol bgp <neighbor IP> extensive

Thank you,

-- 
Doug Hanks - JNCIE-ENT #213,  JNCIE-SP #875
Sr. Systems Engineer
Juniper Networks



On 10/21/11 9:15 AM, "Loopback EZ" <loopback at ezxyz.com> wrote:

>I am replacing an old Cisco router with a Brocade MLX as IBGP peer to a
>Juniper M10.  I am only getting 250K routes and I have NO filtering
>enabled.  I know that the Juniper is receiving a full EBGP route table
>but is only passing 250K to any of its internal IBGP peers including the
>old Cisco.  Suspect that there is route summarization happening so it
>would not overrun an old Cisco SUP module.  Where should I look for
>summarization or any other possible cause in the Juniper config?
>
>
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/juniper-nsp