[j-nsp] IPFIX - "no template found" in wireshark of Flow Collector

[Arun Kumar]

Hi,

After I decoded the packet capture as cflow only, i m seeing that output
(no template found). Its there under Data section of Cisco NetFlow/IPFIX.

On Sat, Mar 24, 2012 at 2:14 PM, Tima Maryin <timamaryin at mail.ru> wrote:

> Hi,
>
> Try Analyze -> Decode as  then cflow
>
>
>
> On 23.03.2012 22:25, Arun Kumar wrote:
>
>> Hi NSP,
>>
>> I configured IPFIX in juniper MX running 11.2 R3. I run wireshark in flow
>> collector where i m getting flows from the juniper router but all data are
>> showing "no template found"? What is the problem in this? I had a problem
>> on the same router where i was told to move to another PIC/port. I ve done
>> the same but now getting this error? What could be the cause of this? Is
>> the router not supporting the flow or not sending the flow in proper
>> format?
>>
>> thanks in advance
>> Arun
>>
>
> ______________________________**_________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/**mailman/listinfo/juniper-nsp<https://puck.nether.net/mailman/listinfo/juniper-nsp>
>