[j-nsp] EX4200 Virtual chassis

[Abdullah]

Yeah this should work, put this config on the current switch, load the new switch on factory-default(if you have done any changes), connect the vc cables and boot up the new switch

Regards
Abdullah Baheer

On Nov 13, 2012, at 7:39 PM, Giuliano Medalha <giuliano at wztech.com.br> wrote:

> You can use the following too:
> 
> set virtual-chassis preprovisioned
> set virtual-chassis no-split-detection
> set virtual-chassis member 0 role routing-engine
> set virtual-chassis member 0 serial-number [SERIAL-1]
> set virtual-chassis member 1 role routing-engine
> set virtual-chassis member 1 serial-number [SERIAL-2]
> 
> 
> set chassis redundancy graceful-switchover
> set ethernet-switching-options nonstop-bridging
> set routing-options nonstop-routing
> set system commit synchronize
> 
> 
> 
> 
> On Tue, Nov 13, 2012 at 1:26 PM, Rachid DHOU <rachid.dhou at gmail.com> wrote:
> 
>> Hi Experts,
>> 
>> If i have a single EX4200 switch and i want to add a new EX4200 switch to
>> it using Virtual chassis capability.
>> 
>> i want to let the old switch as a master and the new one as backup.
>> i will keep new switch OFF.
>> 
>> on the old switch :
>> 
>> set member 0 mastership-priority 255
>> set member 1 mastership-priority 255
>> 
>> reload new switch.
>> 
>> shall i need to reboot also the old switch ?
>> did i forget something to create the Virtual Chassis ?
>> 
>> 
>> *Kind regards,*
>> *Rachid DHOU*
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp