[j-nsp] MX80 Sampling - High CPU

[Jordan Whited]

-idle before, takes 10-15 minutes to settle after full table is ingested
-1m
-no 64-bit release for mx80

On Tue, Jan 6, 2015 at 5:13 PM, Masood Ahmad Shah <masoodnt10 at gmail.com>
wrote:

> Jordan,
>
> How does CPU utilization looks during these 3 minutes (even a minute
> before and after)?
> How many routes (prefixes) you have in the RIB (not just active, the total
> number of prefixes that are being scanned to find out the best routes
> "adj-in-rib")?
> With 14.1R3.5, did you use rpd-64bit or 32bit?
>
> Cheers,
> Masood
>
>
> On Sun, Jan 4, 2015 at 9:30 AM, Jordan Whited <jwhited0917 at gmail.com>
> wrote:
>
>> I don't have any issues when sampling is disabled.
>>
>> No improvement from what I can tell between 12.3R8.7 and 14.1R3.5. Still
>> seeing active-paths in the RIB advertised to other neighbors for upwards
>> of
>> 3 minutes before they are installed in the FIB.
>>
>> On Sat, Dec 13, 2014 at 3:34 AM, MSusiva <ssiva1086 at gmail.com> wrote:
>>
>> > I assume, the 3mins result is with sampling?
>> > What is the result without sampling?
>> > Did you test in 14.1 with sampling?
>> >
>> > Thank You
>> > _______________________________________________
>> > juniper-nsp mailing list juniper-nsp at puck.nether.net
>> > https://puck.nether.net/mailman/listinfo/juniper-nsp
>> >
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>
>
>