[j-nsp] EX3300 : Pbm with inerfaces SFP

[Raphael Mazelier]

Le 26/05/15 18:25, deloin.robert at laposte.net a écrit :
> Hello,
>
> I configured an EX3300-48T. The 4 interfaces SFP have the same configuration
> When I connect the optical fiber in the optical transceiver, I have the green led on the each interfaces.
> But if I can ping IP @ of the switch (or the gateway) on interfaces ge-0/1/0 and ge-0/1/1 ,
> I can't ping the IP @ of the switch on interfaces ge-0/1/2 and ge-0/1/3.
> I don't understand why the interfaces ge-0/1/2 and ge-0/1/3 are not in order. I have the following error message: "No route to host"
>
> Can you help me to understand that ?
>

By default xe-0/1/2 and xe-0/1/3 are reserved for VCP.
So when you do "show interface terse" , you don't show them, but you 
show vcp interface instead.

You can use these interface with the following command :

request virtual-chassis vc-port delete pic-slot 1 port 2
request virtual-chassis vc-port delete pic-slot 1 port 3


Regards,

-- 
Raphael Mazelier