[j-nsp] QFX10K port shaping

[Damian Holdcroft]

Try configuring with "forwarding-class-sets". It looks the same as CoS on
QFX5K:

set class-of-service interfaces et-0/0/0 forwarding-class-set TEST
output-traffic-control-profile TEST


On Fri, Feb 21, 2020 at 5:22 PM Saku Ytti <saku at ytti.fi> wrote:

> On Fri, 21 Feb 2020 at 02:48, Chen Jiang <ilovebgp4 at gmail.com> wrote:
>
> > I have tried you advice but there is no "output-traffic-control-profile"
> under "class-of-service interfaces et-x/x/x" in QFX10K. different from
> other Juniper gears, QFX COS configuration is very weired.
>
> This works in PTX10k and PTX1k which is 100% same PE chip, but
> unfortunately the whole catalyst6500/7600 issue with different
> software. So certainly something PE chip can do, but I don't have
> QFX10k handy to check if this is exist in any QFX10k release. I would
> either check later release in lab or ask account team.
>
>
> --
>   ++ytti
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>